Getting started with Euphonium~
The fastest way to give euphonium a go is to use prebuilt version from github releases.
Required hardware for esp32:~
- Any ESP32 chip with at least 4MB of flash and 4MB of PSRAM. Wrover chips are usually a good call :)
Installing a prebuilt version~
Flashing a prebuilt version only consists of a few steps:
- Download the newest release. (File with name euphonium-vX.X.X.tar.gz
)
- Unpack it
- Flash it by running sh flash_all.sh {your serial port}
-
Configuring the system~
- Reboot the board after flashing.
- After few seconds "Euphonium" network should appear.
- Connect to it. The password is
euphonium
. - You will now be taken to the WiFi configuration page. In case the page does not open automatically - connect to
192.168.4.1
DAC configuration~
In the "DAC configuration" section you can configure the DAC. Euphonium provides an automated configurator for more popular systems. But you can also manually select, and configure the DAC pins.
Enjoy your music~
This is all that's required to get euphonium up and running.